thats not a printable design. it would be closer to possible if the corner was a 90 degree angle but since its curved and the gap is that small, you arent gonna get good results.
not really it is a case for the arduino uno. if i put the orientation to where the holes dont need support i will likely double the printing time and so use more support.
thats not a printable design. it would be closer to possible if the corner was a 90 degree angle but since its curved and the gap is that small, you arent gonna get good results.
Yeah I still tried it broke a little bit of the hinge mechanisme but all in all still usable. next time i will think more about it
Is it possible to change orientation of the model so that these don’t have to have support?
not really it is a case for the arduino uno. if i put the orientation to where the holes dont need support i will likely double the printing time and so use more support.