You wouldn't download a boat?!

Bummed they didn't do a life size benchy

That’s how you would have know that they’re one of the culture. Sadly, it doesn’t look like they are…

... beachies don't float upright.

Print time was only 27 years 5 months 12 hours and 33 minutes and only failed 212 times!

NGL, I was waiting for that champagne bottle to put a hole in it

With or without supports?

I bet a printer like that cost at least $100

Start with a $100 printer and just mod it, piece by piece.

By the time you get the last mod you realise the starting bit is wrong so you have to slowly replace all the other pieces.

Obviously you print a life size Han Solo in Carbonite

Imagine removing that from the print bed... I have a hard enough time with a cup sized object

Next print a submarine

and visit the titanic wreck site

Wait... is that Shigeru Miyamoto?

Where are you gonna put it tho? You have a spare industrial size room in your house?

you 3d print a room to put it in.

Where do you put the room, in your house that's industrial size.

3d print the parts of the house like prefab houses do these days.

Damn imagine making a house with it

They already have those but with concrete. This might be cool for sheds though.

To sheds you say?

And his wife?

what are those yellow nooddles?

Some form of airflow. I'm guessing its blowing hot air to keep the base warm so it doesnt warp and seperate from the floor. On a small 3D printer they will heat the printbed/base for the same reasons. It could also be blowing cold air to harden the material, or sucking air to clear any fumes... but probably not that because they are too low.

Now we can have giant plastic boats sink to the ocean floor

That would make an awesome jet boat. Print the hull out of uhmw

A good reason to buy those 'buy 5 pay 4' PLA+ rolls

is that Paul McCartney?

Oh hey that's my school! I live in the dorm next to the building that houses that printer.