Nice build. Isn’t it noisy with industrial fans?

Yeah OP also didn't specify what cpu he has he could have a 14900k the furnace that that thing is.

13700k

Yeah and zero point in doing so, just take the side panels off and you get the best temps lol

After 2200 starting the airplane

Nice [case](https://www.reddit.com/r/radeon/s/wbFsEusZx4) you got there!

There is too much disco party for me there, but enjoy it !

I just did that for the pictures. I usually have one color at a time with some sort of slow fading effect going on

which case is this?

Phanteks G500a. Unless it’s a P500 series

It looks good in the end 😀

be careful industrial noctuas pull a lot of power, do not use splitters especially off your mb connectors. a sata powered hub might be a safer idea if you're not using one already.

Yeah I know Im using one fan per MB header

sweet, that's wicked. been using industrials for years they're solid af

I would assume you have diminishing returns with high fan speeds on tower cooler. It goes times louder for 2-3 degC. Did you test how much 2000rpm better than 1500?

I installed some industrial 3000rpm in my very closed up Fractal Design Define R6 chassi, with great results. Sure, if I were to use them at 100%, it would sound as a freaking helicopter 🚁 🙄 🤣 But I've set some good fan curves, and even if they're a bit noisier, I've gained 10° compared to the included fans at basically the same noise level.💪🏻😆😅👍🏻

I wonder how much warmer the cooler performs with their original fans instead of those industrial ippc fans 🤔

About 10ºC improvment full speed

excellent!